Clarke 4500615 Instructions d'utilisation et d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 4500615. Clarke 4500615 17 pages.
Imprimer la page
SPEED SELECTION
1. Three running speeds are
available by moving the rocker
switch shown.
LOOSENING A NUT
1. Fit the appropriate socket to the square drive of the impact wrench.
2. With the FORWARD/REVERSE switchbar in the REVERSE running position,
hold the wrench firmly and pull the trigger. The nut will be impacted
repeatedly until it is loosened.
WARNING: ENSURE THAT THE CORRECT SOCKET IS BEING USED FOR THE
NUTS ON YOUR PARTICULAR VEHICLE. AN INCORRECT SOCKET SIZE WILL
DAMAGE THE HEADS OF THE BOLTS/NUTS.
NOTE: As the battery becomes discharged the power available will
drop. The battery will cut out when a low state of charge is
reached. This is normal and is a design feature to protect the
battery from deep discharge. If this occurs, re-charge the battery
as described on page 8.
3. After use, recharge the battery pack as shown on page 8. Avoid leaving
the batteries in a discharged state.
TIGHTENING A NUT
1. Start the nut by hand, ensuring it is not cross threaded, then with the
appropriate socket fitted to the impact wrench, place it on the nut.
2. With the FORWARD/REVERSE selector bar in the forward running position,
and holding the wrench firmly, pull the trigger.
3. Install each nut in turn until it is 'nipped' up only - do not tighten fully. When
all nuts are secure, tighten further but take care to prevent over-tightening.
4. ALWAYS finish tightening with a torque wrench to the manufacturers
recommended torque.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10