Clarke 4500615 Kullanım ve Bakım Talimatları - Sayfa 10

Elektrikli Alet Clarke 4500615 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke 4500615 17 sayfaları.

SPEED SELECTION

1. Three running speeds are

available by moving the rocker

switch shown.

1. Fit the appropriate socket to the square drive of the impact wrench.

2. With the FORWARD/REVERSE switchbar in the REVERSE running position,

hold the wrench firmly and pull the trigger. The nut will be impacted

repeatedly until it is loosened.

WARNING: ENSURE THAT THE CORRECT SOCKET IS BEING USED FOR THE

NUTS ON YOUR PARTICULAR VEHICLE. AN INCORRECT SOCKET SIZE WILL

DAMAGE THE HEADS OF THE BOLTS/NUTS.

NOTE: As the battery becomes discharged the power available will

drop. The battery will cut out when a low state of charge is

reached. This is normal and is a design feature to protect the

battery from deep discharge. If this occurs, re-charge the battery

as described on page 8.

3. After use, recharge the battery pack as shown on page 8. Avoid leaving

the batteries in a discharged state.

1. Start the nut by hand, ensuring it is not cross threaded, then with the

appropriate socket fitted to the impact wrench, place it on the nut.

2. With the FORWARD/REVERSE selector bar in the forward running position,

and holding the wrench firmly, pull the trigger.

3. Install each nut in turn until it is 'nipped' up only - do not tighten fully. When

all nuts are secure, tighten further but take care to prevent over-tightening.

4. ALWAYS finish tightening with a torque wrench to the manufacturers

recommended torque.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]