Clarke 6500005 Instructions d'utilisation et d'entretien - Page 13
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 6500005. Clarke 6500005 19 pages. Mortising machine
Imprimer la page
ADJUSTING CHISEL PARALLEL TO WORKPIECE
It is important that the chisel is
square to the workpiece. To
achieve this, slacken the chisel
securing screw and rotating the
chisel until the back surface is flat
against the workpiece, or a piece
of wood with parallel sides, resting
against the fence, then re-tighten
the screw, ensuring a distance of
at least 1/16" (2mm) is maintained
between the chisel and the end of
the drill bit.
It is also IMPORTANT to remember
that the slot in the side of the chisel
should always face TOWARDS THE DIRECTION OF MOVEMENT OF THE WORKPIECE
(see diagram below).
Chisel slot
on left
Move timber in
this direction
ADJUSTING THE DEPTH STOP
A depth stop is provided which may be used to limit
the depth of the chisel cut.
To adjust the depth stop, slacken the securing knob
so that the stop is capable of being moved, but will
not drop under its own weight, then raise the stop so
that it contacts the underside of the head.
Lower the head to the maximum depth desired, then
tighten the stop securing knob.
ADJUSTING THE HOLD DOWN
The purpose of the 'Hold Down' in to prevent the workpiece from lifting as the
chisel is raised up, out of the hole.
The hold down should be adjusted so it just touches the top of the workpiece and
allows the workpiece to slide left or right. Packing pieces may be used if necessary.
14
13
13
Chisel slot
on right
Move timber in
this direction