Clarke 6500005 Instructions d'utilisation et d'entretien - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 6500005. Clarke 6500005 19 pages. Mortising machine
Imprimer la page
Alternatively, grind off a portion of the drill shank.
This adjustment is IMPORTANT, to ensure a proper clearance is provided between
the cutting tips of the bit and the points of the chisel.
For certain types of wood, it may be necessary to increase this distance up to
a maximum of 3/16" (5mm).
commences and chips are not being ejected satisfactorily.
ADJUSTING THE FENCE
The fence can be moved in or out, by slackening
the locking lever, sliding the fence to the desired
position and re-tightening the locking lever.
Alternatively, precise control is possible by using
the device shown in the illustration opposite.
Slacken the fence locking lever, then screw the
adjuster in or out as required. The fence will move
accordingly.
When the workpiece, being held to the fence, is
lined up as required, tighten the Locking Lever.
The adjuster assembly may be positioned
anywhere on the stem of the fence to provide
adequate adjustment, depending upon how far
IN or OUT the fence is required to be.
11. Push the drill bit up through chisel, and into
11
the opened jaws of the chuck as far as it will
go, then back off approx. 1/16"(2mm).
Secure the drill bit in this position, by tightening
the jaws using the chuck key provided.
Note:
It is important that the
drill bit bottoms out on
the CHISEL and NOT
the chuck, before
setting
(2mm) clearance.
If the bit does bottom
out in the chuck first,
slacken off the grub
screw securing the
chisel and lower it
approx 1/16" (2mm)
and
This will become obvious when cutting
12
the
1/16"
try
again.
12