- ページ 12

電動工具 Clarke 6500005のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6500005 19 ページ。 Mortising machine

Alternatively, grind off a portion of the drill shank.

This adjustment is IMPORTANT, to ensure a proper clearance is provided between

the cutting tips of the bit and the points of the chisel.

For certain types of wood, it may be necessary to increase this distance up to

a maximum of 3/16" (5mm).

commences and chips are not being ejected satisfactorily.

ADJUSTING THE FENCE

The fence can be moved in or out, by slackening

the locking lever, sliding the fence to the desired

position and re-tightening the locking lever.

Alternatively, precise control is possible by using

the device shown in the illustration opposite.

Slacken the fence locking lever, then screw the

adjuster in or out as required. The fence will move

accordingly.

When the workpiece, being held to the fence, is

lined up as required, tighten the Locking Lever.

The adjuster assembly may be positioned

anywhere on the stem of the fence to provide

adequate adjustment, depending upon how far

IN or OUT the fence is required to be.

11. Push the drill bit up through chisel, and into

the opened jaws of the chuck as far as it will

go, then back off approx. 1/16"(2mm).

Secure the drill bit in this position, by tightening

the jaws using the chuck key provided.

Note:

It is important that the

drill bit bottoms out on

the CHISEL and NOT

the chuck, before

setting

(2mm) clearance.

If the bit does bottom

out in the chuck first,

slacken off the grub

screw securing the

chisel and lower it

approx 1/16" (2mm)

and

This will become obvious when cutting

the

1/16"

try

again.