Clarke CSB34 Manuel d'utilisation et d'entretien - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CSB34. Clarke CSB34 12 pages. Siphon feed
Imprimer la page
5. Fit the leg/prop stand to the drum
and secure in place using 2 short
bolts (1), 4 washers (3) and 2 nuts
(7).
6. Secure in leg/prop stand to the
lower frame using the long bolt
(9), 2 washer (3) and 1 nut (7).
7. Place a jubilee clip (8) onto each
end of the hose.
8. Firmly push the end of the hose
onto the abrasive inlet on the
sandblasting gun.
9. Slide one of the jubilee clips so
that it is overlapping both the
hose and the abrasive inlet.
10. Tighten the jubilee clip with a
screwdriver.
11. Firmly push the opposite end of
the hose onto the abrasive outlet,
located at the base of the drum.
NOTE: there is an air hole in the
abrasive outlet - do not
cover this air hole with the
abrasive hose.
12. Position the remaining jubilee clip
so that it is overlapping both the
hose and the abrasive outlet of
the drum.
13. Tighten the jubilee clip with a screwdriver.
6