Zanussi ZOG21317XK Manuel de l'utilisateur - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZOG21317XK. Zanussi ZOG21317XK 28 pages.

Imprimer la page

4. Slowly move it to the left side. Do not apply

force to the wire of the spark plug

connector (F) and to the thermocouple

conductor (E).

5. Release the burner injector (D) with a 7 mm

socket spanner and replace it with a

different one which is necessary for the type

of gas you use.

Refer to "Technical information" chapter.

6. Assemble the burner in a reverse sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new gas

type.

The gas oven burner does not need any primary

gas regulation.

Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

If the supply gas pressure is

changeable or different from the

necessary pressure, you must fit an

applicable pressure adjuster on the

gas supply pipe.

Minimum level adjustment of the oven

burner

1. Disconnect the appliance from the

electricity.

2. Turn the knob for the gas control to the

minimum position and remove it.

3. Adjust the adjustment screw (A) with a thin-

bladed screwdriver.

4. Attach the knob for the gas control.

5. Connect the appliance to the electricity.

6. Light the gas oven burner.

7. Set the knob for the gas control to the

8. Turn the knob for the gas control from the

Control the flame. If the flame goes out, do the

procedure again. There must be a small regular

flame on the oven burner crown.

The manufacturer objects liability if you

do not obey to this safety measures.

Building in

• Only set up the appliance in a kitchen or in a

kitchen-dining room. Do not set up the

appliance in a bathroom or a bedroom.

• You can install the appliance "built-in" or

"built-under". The dimensions of the built-in

cabinet must agree with the related

illustrations.

Change of

the type of

gas

From natural gas

to liquid gas

From liquid gas

to natural gas

WARNING!

Only put the mains plug into the

mains socket when all parts are

back into their initial position. There

is a risk of injury.

Refer to "Daily use" chapter.

maximum position and let the oven heat for

at least 10 minutes.

maximum to the minimum position.

Adjustment

of the adjust-

ment screw

Fully tighten the

adjustment

screw in.

Release the ad-

justment screw

approximately

1/3 of a turn.