Zanussi ZOG21317XK Podręcznik użytkownika - Strona 22
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piekarnik Zanussi ZOG21317XK. Zanussi ZOG21317XK 28 stron.
Drukuj stronęD
E
F
4. Slowly move it to the left side. Do not apply
force to the wire of the spark plug
connector (F) and to the thermocouple
conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one which is necessary for the type
of gas you use.
Refer to "Technical information" chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
Minimum level adjustment of the oven
burner
1. Disconnect the appliance from the
electricity.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a thin-
bladed screwdriver.
22
4. Attach the knob for the gas control.
5. Connect the appliance to the electricity.
6. Light the gas oven burner.
7. Set the knob for the gas control to the
8. Turn the knob for the gas control from the
Control the flame. If the flame goes out, do the
procedure again. There must be a small regular
flame on the oven burner crown.
The manufacturer objects liability if you
do not obey to this safety measures.
Building in
• Only set up the appliance in a kitchen or in a
kitchen-dining room. Do not set up the
appliance in a bathroom or a bedroom.
• You can install the appliance "built-in" or
"built-under". The dimensions of the built-in
cabinet must agree with the related
illustrations.
A
Change of
the type of
gas
From natural gas
to liquid gas
From liquid gas
to natural gas
WARNING!
Only put the mains plug into the
mains socket when all parts are
back into their initial position. There
is a risk of injury.
Refer to "Daily use" chapter.
maximum position and let the oven heat for
at least 10 minutes.
maximum to the minimum position.
Adjustment
of the adjust-
ment screw
Fully tighten the
adjustment
screw in.
Release the ad-
justment screw
approximately
1/3 of a turn.
www.zanussi.com