Zanussi ZDW 416 BU Livret d'instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZDW 416 BU. Zanussi ZDW 416 BU 16 pages. Dishwasher zdw 416 fs; zdw 416 bu

Imprimer la page

INSTALLATION

Remove all packaging before positioning the

machine.

Positioning

(ZDW 416 FS)

If possible, position the machine next to a water tap

and a drain.

The sides and the back of the dishwasher can rest

against the adjacent furniture or the wall.

The dishwasher features fill and drain hoses which

can be turned either to the left or the right to suit the

installation.

Levelling

(ZDW 416 FS)

Good levelling is essential for correct closure and

sealing of the door.

If the door does not close correctly, loosen or tighten

the adjustable support feet, until the machine is

perfectly level.

IN01

Adjusting the worktop

You can move the worktop forward or backward by 25

mm in order to align the machine with other kitchen

units.

Simply unscrew the two front retaining screws, move

the top to the required position and then retighten the

screws.

IN03

(ZDW 416 FS)

Installing and securing the machine under a

kitchen unit

(ZDW 416 FS)

(sink-worktop unit)

By removing the machine's worktop, you can install it

under a close fitting sink unit or a pre-existing top, if

the dimensions of the recess correspond to those

shown in the picture.

Then proceed as follows:

Remove the machine worktop by unscrewing the two

front retaining screws, pull from the front and slide out

the rear slots, lifting the worktop.

Insert the machine after adjusting the height and level-

ling with the adjustable feet. When inserting the ma-

chine, ensure that the water inlet and drain hoses are

not kinked or squashed.

IN05

Caution

Once the machine has been installed, ensure that it

can be accessed easily for servicing.

Fitting a decor panel on the door

(ZDW 416 FS - ZDW 416 BU)

The door of this machine has frames for fitting a

plastic laminate decor panel in the colour required to

match the dishwasher with the rest of the kitchen

furniture. If you wish to do this you must provide the

panel yourself.

Width:

588 mm

Height:

586 mm

Max thickness:

To fit the panel

AP01

Note:

The panel should be fitted before positioning the machine.

PIN24GB

4 mm

Take the door frame off

after removing the retain-

ing screws around the

edge.

Position the panel, refit

the frame and tighten the

retaining screws around

the edge.