Zanussi ZDW 416 BU Livret d'instructions - Page 6

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZDW 416 BU. Zanussi ZDW 416 BU 16 pages. Dishwasher zdw 416 fs; zdw 416 bu

Imprimer la page

Water outlet connection

The end of the drain hose can be connected as

follows:

to the sink outlet siphon, securing it if necessary with

a clip;

to a wall outlet provided with vent-hole, minimum

internal diameter 4 cm;

hooked over the edge of the sink using the special

curved plastic guide provided (ZDW 416 FS).

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the

floor.

It makes no difference which way the drain hose

faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer

than 2 metres and its internal diameter must be no

smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used

for connection to the waste outlet must be no smaller

than the diameter of the drain hose.

CS12

Water supply connections

This dishwasher may be fed with either hot (max.

60°C) or cold water.

Nevertheless we advise you a cold water supply.

A hot water supply is not always efficient with very

soiled crockery as it shortens the washing pro-

grammes a lot.

Feeding the appliance with a hot water supply (max.

60°C) will allow you to obtain considerably shorter

programmes.

For making the connection itself, the coupling nut fitted

to the machine's supply hose is designed to screw on-

to either a 3/4 inch gas thread spout, or to a

purpose-made quick-coupling tap such as the Press-

Block.

+ 2 m max

To make this easier, the hose itself may be turned to

the left or the right. In either case, be sure that the

strainer (A) is incorporated. (See figures).

CA02

ZDW 416 FS

The water pressure must be within the limits given in

the technical specifications, as it will not function

correctly if pressure is outside these specifications.

Warning: the retaining ring must be properly fitted so

as to avoid water leaks.

CA06

Avoid bends or kinks in the hose, which could prevent

or slow down the flow of water.

If the machine is connected to new pipes or pipes

which have not been used for a long time, you are

advised to run the water for a few minutes before

connecting the inlet hose. This will prevent deposits of

sand or rust clogging the inlet hose filter.

Electrical connection

Before plugging the appliance into the wall socket,

make sure that:

1. the mains voltage corresponds to the voltage given

in the technical specifications;

2. the meter, fuses, mains power supply and wall

socket can all take the maximum load required.

Make sure that the socket and plug are compatible

without having to use any type of adaptor. If neces-

sary, have the domestic wiring system socket

replaced.

Safety standards require the appliance to be

earthed.

The Manufacturer accepts no liability for failure to

observe the above safety precautions.

PIN25GB

CA03

ZDW 416 BU

Note: the end of the hose

connected to the machine

can be positioned as re-

quired, by simply slacken-

ing the retaining ring.

Re-tighten the ring securely

to avoid water leaks.