Zanussi ZGF 7899 Livret d'instructions - Page 11

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZGF 7899. Zanussi ZGF 7899 11 pages.

Imprimer la page

Electrical

connections

Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person, in

accordance with the current regulations.

THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should

these safety measures not be observed.

This appliance is designed to be connected to

a 230 V 50 Hz AC electrical supply.

Before the appliance is connected:

1) check that the main fuse and the domestic

installation can support the load (see the rating

label);

2) check that the power supply is properly earthed

in compliance with the current rules;

3) check the socket or the double pole switch used

for the electrical connection can be easily

reached with the appliance built in the forniture

unit. Before switching on, make sure the

electricity supply voltage is the same as that

indicated on the appliance rating plate. The

rating plate is located on the bottom of the hob.

A copy is attached on the back cover of this book.

The appliance is supplied with a 3 core flexible

supply cord incorporating a plug. Connect the plug

to an adequate socket.

Permanent Connection

In the case of a permanent connection, it is

necessary that you install a double pole switch

between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm between

the switch contacts and of a type suitable for the

required load in compliance with the current electric

regulations.

The switch must not break the yellow and green

earth cable at any point and it should be 2-3 cm.

longer than the other cables.

Ensure that the hob supply cord does not come

into contact with surfaces with temperatures

higher than 50 deg. C.

Commissioning

When the hob has been fully installed it will be

necessary to check the minimum flame setting.

To do this, follow the procedure below.

- Turn the gas tap to the MAX position and ignite.

- Set the gas tap to the MIN flame position then

turn the control knob from MIN to MAX several

times. If the flame is unstable or is extinguished

follow the procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob, insert a thin bladed

screwdriver down the centre of the gas tap

control shaft and turn the adjustment screw

until the flame is steady and does not

extinguish, when the knob is turned from MIN

to MAX. Repeat this procedure for all

burners.

By-pass screw

Fig. 6