Zanussi ZFG06400WA Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZFG06400WA. Zanussi ZFG06400WA 12 pages.
Également pour Zanussi ZFG06400WA : Manuel de l'utilisateur (12 pages)
Imprimer la page
the defrosting process, other than those recommended by the
manufacturer
• Do not damage the refrigerant circuit
• Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer
• Do not use water spray and steam to clean the appliance
• Clean the appliance with a moist soft cloth Only use neutral
detergents Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects
• Do not store explosive substances such as aerosol cans with
a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarlyqualified persons in
order to avoid a hazard
Safety Instructions
Installation
WARNING!
Only a qualified person must install this
appliance
• Remove all the packaging
• Do not install or use a damaged appliance
• Obey the installation instruction supplied with
the appliance
• Always be careful when you move the appli-
ance because it is heavy Always wear safety
gloves
• Make sure the air can circulate around the
appliance
• Wait at least 4 hours before connecting the
appliance to the power supply This is to allow
the oil to flow back in the compressor.
• Do not install the appliance close to radiators
or cookers, oven or hobs
• The rear of the appliance must stand against
the wall
• Do not install the appliance where there is
direct sunlight
• Do not install this appliance in areas that
are too humid or too cold, such as the
construction appendices, garages or wine
cellars
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
www.zanussi.com
ZANUSSI_ZFG06400WA_Hungary.indd 3
Electrical connection
WARNING!
Risk of fire and electrical shock.
• The appliance must be earthed
• All electrical connections should be made by
a qualified electrician.
• Make sure that the electrical information on
the rating plate agrees with the power supply
If not, contact an electrician
• Always use a correctly installed shockproof
socket
• Do not use multi-plug adapters and extension
cables
• Make sure not to cause damage to the
electrical components (e g mains plug, mains
cable, compressor) Contact the Service or an
electrician to change the electrical compo-
nents
• The mains cable must stay below the level of
the mains plug
• Connect the mains plug to the mains socket
only at the end of the installation Make sure
that there is access to the mains plug after
the installation
• Do not pull the mains cable to disconnect the
appliance Always pull the mains plug
3
4/1/2015 3:30:00 PM