Zanussi ZFT610X Manuel d'instruction - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Zanussi ZFT610X. Zanussi ZFT610X 16 pages. Freezer zft 610 x
Également pour Zanussi ZFT610X : Manuel de l'utilisateur (16 pages)
Imprimer la page
ance, from where it can be diverted into the tray and
then disposed of.
6. To accelerate the defrosting process place a bowl of
hot (not boiling) water inside the freezer and close the
door.
If the appliance is not working correctly, please carry out the following checks before contacting your local Zanussi Service
Force Centre.
Problem
No power to the appliance
The temperature in the appli-
ance is too high
The temperature in the appli-
ance is too low
Excessive frost and ice has
built up
The appliance is noisy.
If after the above checks your appliance still does not
operate correctly, contact your local Zanussi Service
Force Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
10
Something Not Working
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control is set at „0".
The appliance is located in an unsuitable
position.
The thermostat control is set too low.
The thermostat control is set too high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
7. When defrosting is completed, dry the interior thor-
oughly, replace the drain spout and close the door.
8. Turn the thermostat control knob back to a medium
setting and leave to run for at least 4 hours with the
'fast freeze' switch on.
9. After the red light has gone out put the foods back.
10. Replace the previously removed food.
Important
A temperature rise of the frozen food packs
during defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as this could damage the appliance
beyond repair.
Check there is power at the socket.
Check there is not a power cut by
checking the household lights.
Check the fuse has not blown.
Check the thermostat setting.
Check the ambient temperature is with-
in the appliances operating limits of 16
°C to 32 °C.
Check that the thermostat control knob
is turned to the correct setting relative
to ambient conditions.
Set the thermostat control knob to a
lower position.
Check the door has not been left open.
Check nothing is preventing the door
from closing.
Check the door gasket is intact and
clean.
Check if the appliance stands stable
(all four feet should be on the floor).
In-guarantee customers should ensure that the
above checks have been made, as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Solution