Zanussi GC 20M Instructions pour l'utilisation et l'entretien - Page 18

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisation et l'entretien pour {nom_de_la_catégorie} Zanussi GC 20M. Zanussi GC 20M 21 pages. Cooker zanussi
Également pour Zanussi GC 20M : Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (20 pages)

Adjustments

Adjusting the primary air

Light the burners and check the flame. If

the primary air needs to be adjusted, set

the sliding sheet-iron ring to be found at

the entrance of the burner's Venturi tube.

By adjusting this ring it is possible to

obtain a steady flame with a correct air-

gas mixture (see Fig. 15 a/b/c).

Adjusting the minimum flame

setting

Worktop burners

Turn the gas tap to minimum, remove the

control knob and with a screwdriver turn

the adjusting screw, which is inside the

gas tap shaft, until a small and steady

flame is obtained. Check stability of flame

by quickly turning the tap from max. to

min., re-adjusting the flame if necessary.

Attention: If the cooker is adjusted for

Methane gas, to convert it to Liquid gas

it will suffice to screw completely in the

minimum adjustment screw, after

changing the main jets.

Oven burner

After keeping the oven in operation for

about 10 minutes on the max. setting

with the oven door closed, turn the

thermostat to position 1, remove the

control knob and then adjust the screw

on top of the control knob shaft until a

steady flame of the right size is obtained.

Too much air

Too little air

Correct flame