Zanussi GC 20M 사용 및 관리 지침 - 페이지 18

{카테고리_이름} Zanussi GC 20M에 대한 사용 및 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi GC 20M 21 페이지. Cooker zanussi
Zanussi GC 20M에 대해서도 마찬가지입니다: 사용 지침 및 관리 매뉴얼 (20 페이지), 사용 지침 및 관리 매뉴얼 (24 페이지), 사용 지침 및 관리 매뉴얼 (24 페이지), 사용 지침 및 관리 매뉴얼 (20 페이지)

Adjustments

Adjusting the primary air

Light the burners and check the flame. If

the primary air needs to be adjusted, set

the sliding sheet-iron ring to be found at

the entrance of the burner's Venturi tube.

By adjusting this ring it is possible to

obtain a steady flame with a correct air-

gas mixture (see Fig. 15 a/b/c).

Adjusting the minimum flame

setting

Worktop burners

Turn the gas tap to minimum, remove the

control knob and with a screwdriver turn

the adjusting screw, which is inside the

gas tap shaft, until a small and steady

flame is obtained. Check stability of flame

by quickly turning the tap from max. to

min., re-adjusting the flame if necessary.

Attention: If the cooker is adjusted for

Methane gas, to convert it to Liquid gas

it will suffice to screw completely in the

minimum adjustment screw, after

changing the main jets.

Oven burner

After keeping the oven in operation for

about 10 minutes on the max. setting

with the oven door closed, turn the

thermostat to position 1, remove the

control knob and then adjust the screw

on top of the control knob shaft until a

steady flame of the right size is obtained.

Too much air

Too little air

Correct flame