Directed Viper 220 MAX Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Viper 220 MAX. Directed Viper 220 MAX 18 pages. Recreational vehicle security system

Imprimer la page

To exit the transmitter learn routine, do one of the following:

■ Turn the vehicle key to the "OFF" position.

■ More than 15 seconds elapses between steps.

■ Valet®/Program switch is pressed too many times.

System features learn routine

The System Features Learn Routine dictates how the unit operates. Due to the number of steps, they have been

broken up into two menus. It is possible to access and change any of the feature settings using the Valet/Program

switch. However, this process can be greatly simplified by using the 998T Bitwriter®. Any of the settings can be

changed and then assigned to a particular transmitter.

If the system was previously programmed using the 998T Bitwriter, the learn routine may be locked. If the siren

generates one long chirp when attempting to program the unit, the learn routine is locked and must be unlocked

using the 998T Bitwriter®.

To access system features learn routine:

Transmit. While holding the Valet®/program switch push in, press on the

the first transmitter (a long chirp will be heard). Press on the

transmitter (a long chirp will be heard).

Ignition. Release the Valet®/program switch. Turn the vehicle key to the "OFF" position.

The siren will give a long chirp. The programming mode has been exited.

Once the programming is done. "Green H 1/5" remove the Green wire from the ground.

Try. Use the arm/disarm button of each transmitter to verify that the security system oper-

ates properly.

Green H 1/5 wire will need to be connected to ground for the learn routine to work.

button of

button of the second