Alecto WS-4900 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Alecto WS-4900. Alecto WS-4900 20 pages. Weather station with wireless outdoor sensor

Imprimer la page

Automatic:

As soon as you install the batteries into the indoor unit, the clock starts searching for the DCF radio signal

to set the correct time and date while the antenna symbol

WS-4900 will start showing the correct time. In extreme cases, it can take over a day before the DCF time

is shown.

while searching for the radio signal, you cannot continuously switch on the display lighting. However

by pressing the ALARM/SNOOZE button, the display lighting will switch on but switches off again

after 5 seconds. As soon as the clock has found the radio signal, or when stopping the search by briefly

pressing the RCC button, the display lighting switches on continuously.

Manually:

If the clock cannot receive the radio signal or cannot receive it well enough, you can set the clock manually

as follows:

1. Press and hold the button

2. Use / to set the time format, then briefly press the

3. Use / to set the hours and then briefly press the

4. Use / to set the minutes and then briefly press the

5. Use / to set the seconds to 0 (this allows you to have the clock run synchronously with your own

clock) and then briefly press the

6. Use / to set the year and then briefly press the

7. Use / to set the month and then briefly press the

8. Use / to set the date and then briefly press the

9. Use / to set the difference in hours as compared to the DCF time. For use in the Benelux, select '0'

and briefly press the

10. Use / to set the language for displaying the days, you may choose from: EN (English), FR (French),

DE (German), ES (Spanish) or IT (Italian), briefly press the

11. Use / to determine whether the clock must automatically switch to daylight saving time (AUTO) or this

must be done manually (OFF), briefly press the

The clock is now set manually.

When the DCF receiver is enabled and a strong signal is being received, the receiver will overwrite the

clock display.

To switch the DCF receiver on/off:

You may switch off the DCF receiver as follows to only display the time and date you've programmed

yourself:

•

to switch off: press and hold the RCC button at the rear of the weather station for 8 seconds until OFF

illuminates and the antenna symbol

You may switch the receiver back on as follows:

to switch on: press and hold the RCC button at the rear of the weather station for 8 seconds until ON

•

illuminates, the antenna symbol

The

symbol in the upper part and in the middle of the display shows the status of the DCF clock:

No symbol:

flashing:

remains lit:

3.5 To reset the rain data:

After everything is installed, press and hold the HISTORY button for 10 seconds to delete all measurement

data up to that moment. This prevents you from seeing measurement data at a later time that was caused

by movements during the installation.

for 2 seconds, 12Hr or 24Hr will appear in the display

button

disappears

starts flashing and the display turns green.

the DCF receiver is switched off; the displayed time is determined by the internal

clock of the weather station

the DCF receiver is switched on and is searching for the DCF signal; the displayed

time is determined by the internal clock of the weather station

the DCF receiver is switched on and is receiving the DCF signal; the displayed time

and date are determined by the atomic DCF clock in Frankfurt

flashes. After several seconds or minutes the

button