Aleko LOCKMASTER L110C Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aleko LOCKMASTER L110C. Aleko LOCKMASTER L110C 17 pages.

ALEKO AC-2000 SLIDING GATE OPERATOR

Driven sprocket

Sprocket cover

Mount the sprocket cover with screws.

Limit switch

AC-2000 -Magnets for limit

Install the magnet as shown in Fig.10 below. The magnet and limit switch are used to

control the position of the gate.

When the magnet is installed, release the gear clutch and push the sliding gate manually to

pre-determine the position. Fix the magnet bracket to the gate and then tighten the gear

clutch. The lower bracket is for open position and upper bracket is for close position.

Finally adjust the magnet to the proper position by moving the gate with the motor. The

magnet should be 10~15mm away from the magnetic limit switch. If it is too far away, the

switch will fail to work. Adjust the position of the magnet until the positions of the opening

and closing meet the requirement.

Please note the position of two magnet brackets (fixed plate) are different: one is

upper and another is lower. Verify and if necessary exchange the two brackets

position. Also if necessary exchange the limit switch wires CL (close) and OP

(open).

Gate operator

Release key

Fig.9

(see Fig.10)

Fig.10 AC-2000

Drive sprocket

Driven sprocket

Gate

Upper and lower Magnets

Magnet bracket

Sprocket cover

Drive sprocket