Aleko Victoria Series Manuel d'installation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aleko Victoria Series. Aleko Victoria Series 20 pages. Sizes 6.5x5 8x6.5 10x8
Également pour Aleko Victoria Series : Instructions pour l'installation et le manuel d'utilisation (12 pages), Manuel d'assemblage (14 pages), Manuel d'installation (17 pages)
Imprimer la page
- 1. Parts Diagram
- 2. Assembly Step One: Preparing Your Work Space
- 3. Assembly Step Four: Torsion Bar Assembly
- 4. Assembly Step Eight: Center Support Assembly
- 5. Installation: Notes about Wall Mounting
- 6. Optional Installation: Adjusting the Awning Pitch/Angle
- 7. Optional Installation: Motor Installation
STEP 7: Left Roller Support Assembly
NOTE: Your awning will come with the roller support attached. Refer to this step if installing a replacement part.
Otherwise, proceed to step 8.
1. With a mallet or hammer, tap the left roller support (D-1) with the motor bracket into the torsion bar.
2. Tighten the bolt inside of the roller support with a wrench.
D-1
D-1
STEP 8: Center Support Assembly
1. With a mallet or hammer, tap left roller supports (U) with the motor bracket into the torsion bar.
2. Tighten the bolt to secure the roller support.
STEP 9: Roller Support Assembly
1. Find the motor (F-1) located in the roller tube. Insert this into the motor bracket (D-5), as shown in step 1 on the
diagram below.
Insert in
D-5
10
U
U
F-1
Step 1