Aleko Victoria Series 설치 매뉴얼 - 페이지 10

{카테고리_이름} Aleko Victoria Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko Victoria Series 20 페이지. Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series에 대해서도 마찬가지입니다: 설치 및 사용 설명서 지침 (12 페이지), 조립 설명서 (14 페이지), 설치 매뉴얼 (17 페이지)

페이지 인쇄

STEP 7: Left Roller Support Assembly

NOTE: Your awning will come with the roller support attached. Refer to this step if installing a replacement part.

Otherwise, proceed to step 8.

1. With a mallet or hammer, tap the left roller support (D-1) with the motor bracket into the torsion bar.

2. Tighten the bolt inside of the roller support with a wrench.

D-1

STEP 8: Center Support Assembly

1. With a mallet or hammer, tap left roller supports (U) with the motor bracket into the torsion bar.

2. Tighten the bolt to secure the roller support.

STEP 9: Roller Support Assembly

1. Find the motor (F-1) located in the roller tube. Insert this into the motor bracket (D-5), as shown in step 1 on the

diagram below.

Insert in

D-5

F-1

Step 1