Aleko Victoria Series 설치 매뉴얼 - 페이지 6
{카테고리_이름} Aleko Victoria Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko Victoria Series 20 페이지. Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series에 대해서도 마찬가지입니다: 설치 및 사용 설명서 지침 (12 페이지), 조립 설명서 (14 페이지), 설치 매뉴얼 (17 페이지)
페이지 인쇄
- 1. Parts Diagram
- 2. Assembly Step One: Preparing Your Work Space
- 3. Assembly Step Four: Torsion Bar Assembly
- 4. Assembly Step Eight: Center Support Assembly
- 5. Installation: Notes about Wall Mounting
- 6. Optional Installation: Adjusting the Awning Pitch/Angle
- 7. Optional Installation: Motor Installation
ASSEMBLY
STEP 1: Preparing Your Work Space
1. Before you begin, it is best to lay out all necessary tools to make setup smoother. Consult the required tools section
for the list of necessary tools.
WARNING
Serious injury can result from removing the wrap too soon.
2. Open the awning box and unwrap each piece carefully to avoid damaging the product.
3. Lay out each piece of the awning to ensure that all pieces are present. Consult the parts diagram for detailed
information regarding parts.
4. Open the small, inner box that contains the small parts and lay them out as well.
STEP 2: Connecting Roller Tubes
1. Gather the three long, silver roller tubes (A-1, A-2, A-3) and lay them in a line.
2. Also gather the two short, silver connector tubes (A-A-1, A-A-2) and lay one between A-1 and A-3, and the other
between A-3 and A-2, as seen in the diagram below.
3. Insert the connector tube (A-A-1) into the interior end of the roller tube on the left (A-1). If insertion is difficult, use a
mallet to tap it into place. One inserted, screw it into place.
4. Repeat this process on the other side; insert the other connector tube (A-A-2) into the interior end of the roller tube
on the right (A-2).
5. At this time, the two connector tubes (A-A-1, A-A-2) will be connected to each of the outer roller tubes (A-1, A-2) and
secured with screws. A portion of the connector pieces will stick out of the roller tubes.
6. Now, connect the third middle roller tube (A-3) to the portion of the connector tube (A-A-1) that is sticking out and
screw it into place, just like in step 3.
7. Repeat this process on the other side; connect the other side of the roller tube (A-3) to the remaining connector
tube (A-A-2).
6
DO NOT remove the safety wrap that holds the awning arms down.
A-1
A-A-1
A-1
A-A-1
A-3
Steps 1 and 2
A-3
A-A-2
Steps 3 - 7
A-A-2
A-2
A-2