Aleko Victoria Series Manuel d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aleko Victoria Series. Aleko Victoria Series 17 pages. Sizes 6.5x5 8x6.5 10x8
Également pour Aleko Victoria Series : Manuel d'installation (20 pages), Instructions pour l'installation et le manuel d'utilisation (12 pages), Manuel d'assemblage (14 pages)
Imprimer la page
STEP 3: Connecting Front Bars
1. Gather the two long, wedge-shaped front bars
2. Also gather the one short, wedge-shaped connection piece
diagram below.
3. Insert the connector piece
into place. Once inserted, screw it into place.
4. At this time, the connector piece
A portion of the connector piece will stick out of the front bar until step 5.
5. Now, connect the second remaining front bar
place, just like in step 3.
6. At this time, you will have one full-length front bar, with both arm pieces connected and screwed securely into place.
STEP 4: Connecting Torsion Bars
1. Gather the two white torsion bars
I
•
WARNING
2. Also gather the one short, rectangular connection piece
diagram below.
�l�
\)L__
���-A-ti � � �)
=
i=i+t
(C-1
C-1
into the interior end of the front bar
(C-3)
will be connected to one of the two front bars
(C-3)
(C-1)
C-1
C-1
(8-1
8-2)
and
DO NOT REMOVE THE SAFETY SLEEVES THAT HOLD THE ARMS DOWN!
B
-
=
==
=� � ����� ���
=P
and
C-2)
and lay them in a line.
(C-3)
and lay it between the two front bars, as seen in the
C- 3
Steps
and 2
7
(C-2).
to the other side of the connector piece
A-A-1
C-3 � �
Steps 3, 4, 5
6
Step
and lay them in a line.
(8-3)
and lay it between the two torsion bars, as seen in the
U';:'.J -
' I
3
11
B-
0
Steps
and 2
7
6
C-2
If insertion is difficult, use a mallet to tap it
and secured with screws.
(C-2)
and screw it into
(C-3)
C-2
C-2