Aleko Victoria Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Aleko Victoria Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko Victoria Series 17 페이지. Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 및 사용 설명서 지침 (12 페이지), 조립 설명서 (14 페이지)

페이지 인쇄

STEP 3: Connecting Front Bars

1. Gather the two long, wedge-shaped front bars

2. Also gather the one short, wedge-shaped connection piece

diagram below.

3. Insert the connector piece

into place. Once inserted, screw it into place.

4. At this time, the connector piece

A portion of the connector piece will stick out of the front bar until step 5.

5. Now, connect the second remaining front bar

place, just like in step 3.

6. At this time, you will have one full-length front bar, with both arm pieces connected and screwed securely into place.

STEP 4: Connecting Torsion Bars

1. Gather the two white torsion bars

•

WARNING

2. Also gather the one short, rectangular connection piece

diagram below.

�l�

\)L__

��-A-ti � � �)

i=i+t

(C-1

C-1

into the interior end of the front bar

(C-3)

will be connected to one of the two front bars

(C-3)

(C-1)

C-1

(8-1

8-2)

and

DO NOT REMOVE THE SAFETY SLEEVES THAT HOLD THE ARMS DOWN!

=� � ��

and

C-2)

and lay them in a line.

(C-3)

and lay it between the two front bars, as seen in the

C- 3

Steps

and 2

(C-2).

to the other side of the connector piece

A-A-1

C-3 � �

Steps 3, 4, 5

Step

and lay them in a line.

(8-3)

and lay it between the two torsion bars, as seen in the

U';:'.J -

' I

B-

Steps

and 2

C-2

If insertion is difficult, use a mallet to tap it

and secured with screws.

(C-2)

and screw it into

(C-3)

C-2