Clarke CMS 200 Instructions d'utilisation et d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CMS 200. Clarke CMS 200 18 pages. 3 in1 multi sander
Également pour Clarke CMS 200 : Manuel d'utilisation et d'entretien (17 pages)
Imprimer la page
ASSEMBLY and INSTALLATION.
The saw is fully assembled and adjusted at the factory. On receipt inspect
the machine to ensure that all parts are accounted for and that no
damage was incurred during transit.
Loose items are: 1x Peg spanner, and 1x Box spanner
Any deficiency or damage should be reported to your CLARKE dealer
immediately.
Mount the machine on a firm solid base that will not move under load.
Ensure there is an appropriate electrical supply, and adequate lighting,
so that you will not be working in your own shadow.
Four holes are provided, one at each corner of the base, so that the
machine may be bolted permanently to a workbench for added stability,
using 8mm bolts (not provided). Alternatively it may be bolted to a piece
of plywood with a thickness of 16mm (5/8").
The Cutting Head is locked in its lower position for transit purposes. To release
it, pull out the Head Locking Knob (B), (It may be necessary to apply slight
downward pressure to the head in order to do so), and allow the head to
rise to its upper position gently, under control.
The head will lock in its upper position, and is prevented from being lowered
until the Head Release Button (A) is pressed
OPERATION.
A. Cross Cutting.
First, set the work in place with one end firmly clamped against the table
and back fence.
It is important to ensure that one end of the workpiece is completely free
to move i.e. NOT clamped or held in any way. This will normally be the off-
cut or shorter end.
NOTE: If the workpiece is not entirely straight, ensure that the portion at
either side of the intended cut rests firmly against the table and back
fence.
When satisfied, make a final check to ensure that all safety precautions
are being complied with, then pull and hold the starter switch (G, Fig.1),
and allow the blade to reach full speed. If any unusual sounds or vibrations
occur, release the starter switch immediately and investigate the cause.
(Ref Fig.4)
(at 90°)
10
Ref: Fig. 3