Alemite 6320-3 Manuel d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Alemite 6320-3. Alemite 6320-3 10 pages. High-pressure control valve

Imprimer la page

SER 6320-3

Installation

Attach the Z-Swivel to the control valve's Inlet

Adapter (18). Tighten connection securely.

Operation and Adjustments

WARNING

Should leakage occur anywhere within the

system, disconnect power to the motor. Personal

injury can occur.

Prime and Test

NOTE: Perform the following procedures at

a pressure not to exceed 3000 psi (207 Bars).

Should valve leakage occur at anytime, refer

to the Troubleshooting Chart.

1. Place the pump in the product to be dispensed.

2. Point the control valve into an appropriate collection

container.

3. Connect the air line to the pump motor.

• The control valve should show no leakage or

dispense the product.

4. Depress the control valve Lever (2) fully.

• Product should flow continuously once air is

eliminated from the control valve (and system).

If the control valve does not dispense the

product, refer to the Troubleshooting

Chart.

5. Release the Lever.

If product appears at Coupler (26):

6. Turn Setscrew (1) counterclockwise until the product

discontinues to flow.

Product Delivery Adjustment (Single-Shot)

IMPORTANT: The adjustment for the single-

s h o t m o d e - o f - o p e r a t i o n e f f e c t s t h e

continuous mode-of-operation. If the single-

s h o t a d j u s t m e n t i s s e t t o o g re a t , t h e

continuous mode-of-operation may be lost.

1. Depress the control valve Lever (2) partially to initiate

the single-shot mode of operation.

Revision (1-13)

If product does not begin to flow or too great

(or too little) an amount is produced, adjustment is

necessary.

2. Make sure to read the following warning.

WARNING

Release all pressure within the system

prior to valve adjustment.

•

Disconnect the air supply line from the pump

motor.

•

Into an appropriate container, operate the

control valve to discharge remaining pressure

within the system.

Personal injury can occur.

3. Loosen Locknut (20) 1/8 turn. See Figure 5.

• Do not allow the Locknut to completely disengage

Single-Shot Adjuster (24).

Refer to Figure 2 Parts List

for Parts Identification

Figure 5 Single-Shot Adjustment Components

WARNING

Do not turn the Single-Shot Adjuster

counterclockwise more than a total of four turns.

Personal injury can occur.

High-Pressure Control Valve

Alemite LLC