Directed Electronics Xpresskit SoleX Series Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Electronics Xpresskit SoleX Series. Directed Electronics Xpresskit SoleX Series 9 pages.

Imprimer la page

The Mobile Integration Systems

Platform: XK09

Firmware: CHRYSLER3

LED Diagnostics and Troubleshooting

LED

Status

Module Programming

Off

Solid

Flashes quickly

Flashes

Solid x3 seconds

Solid

x3 secs

then OFF

Flashes once

Flashes

quickly

Flashes twice

Flashes

pattern

Active Ground While Running

Solid

Off

Flashes for

Flashes

x1 sec

1 second

Flashes

Inactive Ground While Running

Off

Flashes for

Flashes

x1 sec

1 second

Solid

Flashes

Description

Module has no power.

Data Bus is not detected.

Module has detected IGN

ON. Waiting for VIN

information.

Module is programmed.

Module was reset.

VIN invalid.

Incorrect behavior.

Ground While Running

(status) OFF.

A command is processing.

Ground While Running

(status) ON.

Ground While Running

(status) OFF.

A command is processing.

Incorrect behavior.

Ground While Running

(status) ON.

Troubleshooting

Verify your powerlines (D2D or W2W).

Make sure the connections of the CAN Bus are correct,

then press the Push-to-Start (PTS) button twice to turn

the ignition ON.

Normal operation.

Contact tech support.

Data is not processing correctly. Disconnect the power

from the module and power up.

Make sure the module was programmed, i.e. the D2D

harness is properly connected or the Ground While

Running (status) wire is connected (if in W2W mode).

Normal operation.

Data is not processing correctly. Disconnect the power

from the module and power up.

Module did not receive ground while running (status)

OFF. Make sure the D2D harness is properly

connected or the ground while running (status) wire is

not shorted to ground.

Rev.: 20111122

Page 7