Clarke CONTRACTOR 6462118 Manuel d'utilisation et d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CONTRACTOR 6462118. Clarke CONTRACTOR 6462118 20 pages. Worktop jig
Imprimer la page
11. Firmly clamp the jig to the worktop ensuring it doesn't move as you do so. Ensure the
clamps do not obstruct the router path.
Fig. 9
Cutting
12.
- follow steps 6 - 9 on page 6.
Female Bolt Recesses (Fig. 10)
13.
14. Fully insert three pins in holes marked 'CB'.
15. Clamp the jig to the worktop ensuring the three pins are firmly pushed up to the cut
out face and the worktop edge. Ensure clamps do not obstruct the router path.
16. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again. Increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
17. Repeat step 16 for the other 2 recesses (other 3 recesses for 900mm worktops).
Recesses must be no deeper than 20mm maximum.
Female bolt recesses - Laminate face down.
-9-
Pencil Line
Male Joint - Laminate face up.
- Place the worktop with the laminate face down.
IMPORTANT
Post Form Edge
Cut Direction
Post Form Edge
Fig. 10