Clarke CONTRACTOR 6462118 Manuel d'utilisation et d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CONTRACTOR 6462118. Clarke CONTRACTOR 6462118 20 pages. Worktop jig
Imprimer la page
Female Bolt Recesses (Fig. 6)
16.
17. Fully insert three pins in holes marked 'CB'.
18. Clamp the jig to the worktop ensuring the three pins are firmly pushed up to the cut
out face and the worktop edge. Ensure clamps do not obstruct the router path.
19. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router
to the back again. Increase the depth of cut a further 10mm and machine the
recess again. When finished, switch the router OFF and wait for it to stop spinning.
20. Repeat step 19 for the other 2 recesses (other 3 recesses for 900mm worktops).
Recesses must be no deeper than 20mm maximum.
Male Bolt Recesses (Fig. 7)
21.
22. Fully insert 3 pins in the holes marked 'CB'.
23. Clamp the jig to the worktop ensuring all 3 pins are pushed firmly against the
worktop. Ensure clamps do not obstruct the router path.
Post Form Edge
-7-
- Place the worktop with the laminate face down.
Female bolt recesses - Laminate face down.
IMPORTANT
- Place the worktop with laminate face down.
Male bolt recesses -
Laminate face down.
Fig. 6
Post Form Edge
Fig. 7