Lenovo Flex System X6 Compute Node Manuel du produit - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Lenovo Flex System X6 Compute Node. Lenovo Flex System X6 Compute Node 36 pages. Compute node

Imprimer la page

Light path diagnostics panel

For quick problem determination when you are physically at the server, the compute node offers a 3-step

guided path:

The Fault LED on the front panel

The light path diagnostics panel

LEDs next to key components on the system board

The light path diagnostics panel is visible when you remove the server from the chassis. The panel is at

the upper right side of the compute node, as shown in the following figure.

Figure 9. Location of X6 light path diagnostics panel

To illuminate the light path diagnostics LEDs, power off the compute node, slide it out of the chassis, and

press the power button. The power button doubles as the light path diagnostics remind button when the

server is removed from the chassis. The meanings of the LEDs are listed in the following table.

Table 15. Light path diagnostic panel LEDs

LED

Meaning

The light path diagnostics panel is operational.

S BRD

A system board error is detected.

MIS

A mismatch has occurred between the processors, DIMMs, or HDDs.

NMI

A non-maskable interrupt (NMI) has occurred.

TEMP

An over-temperature condition occurred that was critical enough to shut down the server.

MEM

A memory fault has occurred. The corresponding DIMM error LEDs on the system board are also lit.

ADJ

A fault is detected in the adjacent expansion unit (if installed).

Flex System X6 Compute Node (7903)