Disaster Area Designs Qconnect Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16 pages. Multi output midi controller

Imprimer la page

lexander

To configure your Alexander Neo pedal with qCONNECT, plug a TS / mono cable from one of the

ports on qCONNECT to the MultiJack on the left side of your Neo pedal.

Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.

Set your desired device mode to ALEX. Remember to hold the right footswitch to save.

Example: If you want to use a Syntax Error as your third MIDI device connected

to Port D, you would set DevC = ALEX, CFG.D = TIP in the qCONNECT Setup

menu.

Power the qCONNECT on, but leave the

Neo pedal off.

Hold and release the right footswitch on the qCONNECT until the device mode that you want to

use is showing.

Example: Navigate to the C device mode - C plus a number will show.

Power on the Neo pedal while holding its center select button.

Release the button when the main LED turns violet.

Tap the center button until the upper small LED is red, then hold Select to

save.

Power the Neo pedal off and back on, again holding the center button until the upper LED turns

violet.

Tap the left or right buttons on the qCONNECT until you see the upper small

LED flash, then hold the select button to save and exit.

Your Neo pedal is now configured!

eries

etup

uide

P 01

C 05

C 03