Disaster Area Designs Qconnect 사용자 설명서 - 페이지 9

{카테고리_이름} Disaster Area Designs Qconnect에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disaster Area Designs Qconnect 16 페이지. Multi output midi controller

lexander

To configure your Alexander Neo pedal with qCONNECT, plug a TS / mono cable from one of the

ports on qCONNECT to the MultiJack on the left side of your Neo pedal.

Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.

Set your desired device mode to ALEX. Remember to hold the right footswitch to save.

Example: If you want to use a Syntax Error as your third MIDI device connected

to Port D, you would set DevC = ALEX, CFG.D = TIP in the qCONNECT Setup

menu.

Power the qCONNECT on, but leave the

Neo pedal off.

Hold and release the right footswitch on the qCONNECT until the device mode that you want to

use is showing.

Example: Navigate to the C device mode - C plus a number will show.

Power on the Neo pedal while holding its center select button.

Release the button when the main LED turns violet.

Tap the center button until the upper small LED is red, then hold Select to

save.

Power the Neo pedal off and back on, again holding the center button until the upper LED turns

violet.

Tap the left or right buttons on the qCONNECT until you see the upper small

LED flash, then hold the select button to save and exit.

Your Neo pedal is now configured!

eries

etup

uide

P 01

C 05

C 03