Disaster Area Designs Qconnect 사용자 설명서 - 페이지 10

{카테고리_이름} Disaster Area Designs Qconnect에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disaster Area Designs Qconnect 16 페이지. Multi output midi controller

eris

edal

To configure your Meris pedal with qCONNECT, plug in a TRS / mono cable from one of the

ports on qCONNECT to the EXP / MIDI jack on the back of the Meris.

Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.

Set your desired device mode to OTTO (OttoBit, Polymoon, Enzo) or MRC7 (Mercury7.)

Remember to hold the right footswitch to save.

Example: If you want to use a Polymoon as your fifth MIDI device connected to Port C, you would set

DevE = OTTO, CFG.C = TIP in the qCONNECT Setup menu.

Power the qCONNECT on, but leave the Meris pedal off.

Power on the Meris pedal while holding the LED button over the left footswitch. All of the

Meris LEDs will blink three times to indicate that it is now in setup mode.

Rotate the lower right knob fully CLOCKWISE to set the EXP jack to MIDI. The far right small LED

will light to indicate MIDI mode.

Rotate the lower middle knob to set the desired MIDI channel - the LEDs on the pedal will light

to show the MIDI channel as you turn the knob. Example: To set the pedal to MIDI channel 5

(DevE,) turn the lower right knob untilthe large LED on the right side is lit.

Power your Meris pedal off and back on to save the configuration.

Your Meris pedal is now configured!

etup

uide

P 01