Disc Makers ReflexMax1 Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Disc Makers ReflexMax1. Disc Makers ReflexMax1 9 pages. Cd reflexmax series
Également pour Disc Makers ReflexMax1 : Manuel de démarrage rapide (1 pages), Manuel de démarrage rapide (2 pages), Manuel de l'utilisateur (13 pages)
Imprimer la page
3. Press the ENT button to start the duplication process. The unit will analyze
the master disc and the source disc. This may take a few minutes.
Upon successful testing, the following will display on the LCD.
Test
OK: 01
If the blank target CD-R in the writer drive has already been written to, or is
damaged and cannot be written to, the LCD will display the message: Target
Drive Not Ready. If the data on the master CD will not fit on the blank target CD,
the LCD display will read Target Overflow.
3. T
C
EST AND
OPY
The Test and Copy Function incorporates the first two functions into one oper-
ation. It is used to check whether a disc will successfully copy and then contin-
ues on with the duplication process. First, the copy process is simulated and
then the data is copied to the blank CD-R.
1. Select the Test and Copy function using the UP and DOWN arrows.
2. Load the top drive (reader) with the master disc and load the lower drive
(writer) with high-quality blank CD-R media.
3. Press the ENT button to start the process. The unit will display Test the
Master Disc, then check the target disc, and finally copy to the blank CD.
Upon successful testing and copying the following will display on the LCD.
Test and Copy
OK: 01
1-888-800-4041
If the blank target CD-R has already been written to, or is damaged and
cannot be written to, the LCD will display the message Target Drive Not
Ready. If the data on the master CD will not fit on the blank target CD, then the
LCD display will read Target Overflow.
4. V
ERIFY
The Verify Function is used to confirm that the master and the copy read the
same after the duplication process is completed.
1. Select the Verify Function using the UP and DOWN arrows.
2. Load the top drive (reader) with the master CD and load the lower drive
(writer) with the CD-R that has been copied.
3. Press the ENT button to start the process.
Upon successful verification, the following will display on the LCD and the
copied disc will be ejected. To verify another disc place another disc in the
writer drive and press the ENT button.
If the verification was unsuccessful, the following will display:
5. C
OMPARE
The Compare Function takes the Verify Function one step farther—it gives
details about the master and copied disc. It also ejects the disc upon a suc-
cessful comparison.
1. Select the Compare Function using the UP and DOWN arrows.
www.discmakers.com
Verify
OK: 01
Verify
F->
Fail: 01
T
05