Disc Makers ReflexMax1 사용자 설명서 - 페이지 6

{카테고리_이름} Disc Makers ReflexMax1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers ReflexMax1 9 페이지. Cd reflexmax series
Disc Makers ReflexMax1에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (1 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄

3. Press the ENT button to start the duplication process. The unit will analyze

the master disc and the source disc. This may take a few minutes.

Upon successful testing, the following will display on the LCD.

Test

OK: 01

If the blank target CD-R in the writer drive has already been written to, or is

damaged and cannot be written to, the LCD will display the message: Target

Drive Not Ready. If the data on the master CD will not fit on the blank target CD,

the LCD display will read Target Overflow.

3. T

EST AND

OPY

The Test and Copy Function incorporates the first two functions into one oper-

ation. It is used to check whether a disc will successfully copy and then contin-

ues on with the duplication process. First, the copy process is simulated and

then the data is copied to the blank CD-R.

1. Select the Test and Copy function using the UP and DOWN arrows.

2. Load the top drive (reader) with the master disc and load the lower drive

(writer) with high-quality blank CD-R media.

3. Press the ENT button to start the process. The unit will display Test the

Master Disc, then check the target disc, and finally copy to the blank CD.

Upon successful testing and copying the following will display on the LCD.

Test and Copy

OK: 01

1-888-800-4041

If the blank target CD-R has already been written to, or is damaged and

cannot be written to, the LCD will display the message Target Drive Not

Ready. If the data on the master CD will not fit on the blank target CD, then the

LCD display will read Target Overflow.

4. V

ERIFY

The Verify Function is used to confirm that the master and the copy read the

same after the duplication process is completed.

1. Select the Verify Function using the UP and DOWN arrows.

2. Load the top drive (reader) with the master CD and load the lower drive

(writer) with the CD-R that has been copied.

3. Press the ENT button to start the process.

Upon successful verification, the following will display on the LCD and the

copied disc will be ejected. To verify another disc place another disc in the

writer drive and press the ENT button.

If the verification was unsuccessful, the following will display:

5. C

OMPARE

The Compare Function takes the Verify Function one step farther—it gives

details about the master and copied disc. It also ejects the disc upon a suc-

cessful comparison.

1. Select the Compare Function using the UP and DOWN arrows.

www.discmakers.com

Verify

OK: 01

Verify

F->

Fail: 01