Disc Makers Elite PowerPro Manuel d'installation et de configuration - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de configuration pour {nom_de_la_catégorie} Disc Makers Elite PowerPro. Disc Makers Elite PowerPro 7 pages. Elite series powerpro thermal printer

Imprimer la page

Elite Setup Guide- Thermal Printer

Thermal Printer Option

Installation of the PowerPro CD Printer

Review the printer documentation included in the carton with the PowerPro printer. Install the thermal

ribbon and ready the printer for printing. Perform and complete any printer checks before installing

the printer onto the Elite unit.

Note to obtain additional supplies for the printer call toll free 1-888-800-4041 or online at

Discmarket.com

The Elite is generally supplied with an Inkjet Printer Tray and this tray must be removed. Please

store this tray if you plan to ever use the Elite for Inkjet printing.

To install the printer onto the Elite unit following these steps:

Install the thermal ribbon and prepare the PowerPro for operation

Install the PowerPro Software located on the CD supplied with the printer documentation.

Remove the Inkjet tray that was shipped on the Elite.

Locate and install the PowerPro Thermal Printer tray onto the Elite Unit

Secure the fasteners snug, but do not tighten.

Place the printer into the print holding tray located at the top of the drive stack. Holding the printer

with hands on the left and right side, insert the front of the printer at an angle first, and then let the

back section "drop into" place. The printer should be securely inserted into the print holder tray and

should be completely level.

Connect the parallel printer cable provided with the Elite into the rear of the printer and connect into

the Elite connector on the rear of the Elite (or to your PC if the you are using an external PC).

Connect the CD Printer mini din control cable to the rear of the Elite and connect the DB9M

connector into mating connector in the rear of the printer.

Connect the AC Power cord that was provided with the CD Printer next to the rear of the printer and

connect into a standard 115VAC outlet.

When you connect the printer and power is applied, the printer will perform a basic internal test and

then wait for additional commands from the operator or the software. Once the printer has completed

it self-tests, you will need to align the printer. First open the printer tray and open one of the drives

below the printer. Look down through the printer tray opening adjust the printer position so that the

center of the tray aligns with the drive tray center. Next close the printer and drive trays.