Blade Vusion 250 V2 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Blade Vusion 250 V2. Blade Vusion 250 V2 18 pages. Fpv-ready racing drone rtf

Imprimer la page

4.3 inch Video Monitor with DVR Features

5.8GHz Antenna connector

Menu Buttons:

Press and hold the M button

to change to playback mode

Single push the M button to select options:

Brightness

Contrast

Color

Language

Backlight

Reset

Use the

and

buttons to modify the

selected option

Micro Memory Card Slot

Using the Video Monitor

CAUTION: Do not power on the monitor without

the antenna attached. Doing so will damage the

video receiver ampliﬁ ers. Ampliﬁ er damage is not covered

by warranty.

1. Before using the 4.3 inch video monitor, make sure

the monitor is fully charged. Connect the micro USB

connector to a 5V USB power source. The charge indicator

LED will glow red while charging and will go off when the

monitor is fully charged.

2. Open the sun shade, if installed.

3. Insert a micro memory card (not included) in the slot on

the side of the video monitor. Press the card in until it

locks. To remove the card, press in slightly and release

until the card is released. Always insert the memory card

before powering on the video monitor.

4. Power on the video monitor and look for a clear channel.

Clear channels will have a consistent static background.

Channels with interference will display horizontal static

lines. Select one of the clear channels.

5. Once you have chosen a clear channel on the monitor,

select the same channel on the video transmitter.

6. Place the monitor in the transmitter cradle or in the

goggle mount.

Band Channel

Clip Timer

Monitor Band

* The video transmitter on the quadcopter does not operate in the E band.

Frequency

Total Time

FPV Band

FS/IRC

Race

Battery Level

Channel Selection Button

Single push to change channel

Band Button

Single push to change band

Press and hold for frequency scan

5V Micro USB Charge Port

Charge Status LED

Red = charging

Off = charged

Power Switch

DVR Start/Stop Button