Blade Vusion 250 V2 Manuel d'instruction - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Blade Vusion 250 V2. Blade Vusion 250 V2 18 pages. Fpv-ready racing drone rtf

Imprimer la page

Video Monitor FPV Goggle

The FPV Goggle is designed to hold the included video

monitor for a more immersive view from the FPV camera.

The goggle can also be used with mobile devices that are

less than 5.9 x 3.15 inches to watch videos. The goggle is

large enough that reading glasses can be used if needed to

sharpen the image from the monitor.

To install the video monitor in the goggle:

1. Remove the sunshade from the video monitor, if installed.

2. Pull on the goggle cover tab to open the goggle cover.

3. Place the monitor or mobile device in the compartment

and close the goggle cover.

Pulling the ﬁ eld of view lever on top of the goggle closer to

your eyes will slightly expand the ﬁ eld of view for use with

devices that have a larger screen.

The length of the straps can be adjusted by moving the hook

and loop pad at the end of each strap.

A small adhesive backed foam pad is included to use to

secure a thin mobile device (less than 3/8"). The pad should

be mounted in the center of the goggle cover. Do not use the

pad with the included video monitor, the magnetic catch on

the cover may not close securely.

Video Transmitter

The Vusion 250 quadcopter comes equipped with a selectable

output (25mW or 200mW), 32 channel video transmitter

installed. The VTX is capable of transmitting on A, B, FS/ I RC

and Race bands. The video transmitter includes a digital

display which continuously scrolls through the active band and

channel. Press down and pull on the rear of the top cover for

access to the video transmitter.

To change the video transmitter ouptut power level:

1. Press and hold band/channel button.

2. When the channel ﬂ ashes on the LCD screen, press and

hold the output power button.

3. Release the buttons when the output symbol, – or =,

appears.

4. Press the band/channel button to change output level.

The following symbols indicate the selected output:

"–" = 25mW.

"=" = 200mW.

5. After 5 seconds of release channel/power selection will

auto exit.

To change the band:

1. Press and hold the band/channel button until the active

band continuously ﬂ ashes in the display.

2. Press and release the band/channel button to scroll

through the available bands.

3. Wait approximately 5 seconds until the digital display

shows the band followed by the channel.

To change the active channel:

Press and release the band/channel button to scroll through

the available channels within the active band.

Field of view lever

LCD display

Output power

button

Band/channel

button

Available Frequencies, (mHz):

Band

CH 1 CH 2 CH 3 CH 4 CH 5 CH 6 CH 7 CH 8

Band A

5865 5845 5825 5805 5785 5765 5745 5725

Band B

5733 5752 5771 5790 5809 5828 5847 5866

FS/IRC

5740 5760 5780 5800 5820 5840 5860 5880

RaceBand 5658 5695 5732 5769 5806 5843 5880 5917