Blade Vusion 250 V2 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drony Blade Vusion 250 V2. Blade Vusion 250 V2 18 stron. Fpv-ready racing drone rtf

Drukuj stronę
EN

Video Monitor FPV Goggle

The FPV Goggle is designed to hold the included video
monitor for a more immersive view from the FPV camera.
The goggle can also be used with mobile devices that are
less than 5.9 x 3.15 inches to watch videos. The goggle is
large enough that reading glasses can be used if needed to
sharpen the image from the monitor.
To install the video monitor in the goggle:
1. Remove the sunshade from the video monitor, if installed.
2. Pull on the goggle cover tab to open the goggle cover.
3. Place the monitor or mobile device in the compartment
and close the goggle cover.
Pulling the fi eld of view lever on top of the goggle closer to
your eyes will slightly expand the fi eld of view for use with
devices that have a larger screen.
The length of the straps can be adjusted by moving the hook
and loop pad at the end of each strap.
A small adhesive backed foam pad is included to use to
secure a thin mobile device (less than 3/8"). The pad should
be mounted in the center of the goggle cover. Do not use the
pad with the included video monitor, the magnetic catch on
the cover may not close securely.

Video Transmitter

The Vusion 250 quadcopter comes equipped with a selectable
output (25mW or 200mW), 32 channel video transmitter
installed. The VTX is capable of transmitting on A, B, FS/  I RC
and Race bands. The video transmitter includes a digital
display which continuously scrolls through the active band and
channel. Press down and pull on the rear of the top cover for
access to the video transmitter.
To change the video transmitter ouptut power level:
1. Press and hold band/channel button.
2. When the channel fl ashes on the LCD screen, press and
hold the output power button.
3. Release the buttons when the output symbol, – or =,
appears.
4. Press the band/channel button to change output level.
The following symbols indicate the selected output:
"–" = 25mW.
"=" = 200mW.
5. After 5 seconds of release channel/power selection will
auto exit.
To change the band:
1. Press and hold the band/channel button until the active
band continuously fl ashes in the display.
2. Press and release the band/channel button to scroll
through the available bands.
3. Wait approximately 5 seconds until the digital display
shows the band followed by the channel.
To change the active channel:
Press and release the band/channel button to scroll through
the available channels within the active band.
Field of view lever
LCD display
Output power
button
Band/channel
button
Available Frequencies, (mHz):
Band
CH 1 CH 2 CH 3 CH 4 CH 5 CH 6 CH 7 CH 8
Band A
5865 5845 5825 5805 5785 5765 5745 5725
Band B
5733 5752 5771 5790 5809 5828 5847 5866
FS/IRC
5740 5760 5780 5800 5820 5840 5860 5880
RaceBand 5658 5695 5732 5769 5806 5843 5880 5917
10