Blade Vusion 250 V2 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drony Blade Vusion 250 V2. Blade Vusion 250 V2 18 stron. Fpv-ready racing drone rtf

Drukuj stronę

FPV Operation

Consult local laws and ordinances before operating FPV

equipment. In some areas, FPV operation may be limited or

prohibited. You are responsible for operating this product in a

legal and responsible manner.

Flying FPV is more difﬁ cult than line of sight, because it is

difﬁ cult to determine altitude with just the camera view.

Practice in an open area with a spotter. If possible, ﬂ y over

tall grass to minimize damage if you crash. When you are

comfortable ﬂ ying in an open area, practice ﬂ ying a pre-set

course. This will help you learn to corner faster.

The quadcopter has a built in camera and 32 channel VTX

that transmits on A, B, F and Race bands. The included

monitor must be set to the correct band and channel to

display the feed from the camera.

Before powering on the quadcopter, always scan the

available video frequencies, using the included video monitor,

to ﬁ nd an open channel.

CAUTION: Do not power on the quadcopter while

others are ﬂ ying FPV around you without ﬁ rst knowing

what band and channel both you and any other pilots are

transmitting on. It is possible to swamp other nearby video

transmitters, causing others to lose video feed and crash.

To scan all available frequencies:

1. Attach the antenna to the FPV monitor and power the

monitor on.

2. Hold button B on the monitor for 2 seconds and release

it. The monitor will scan all bands and channels and lock

onto any currently occupied channel.

3. Press and release button B to change bands.

IMPORTANT: The video monitor displays A, B, E, F and

Race bands. The quadcopter video transmitter does not

operate in the E band.

4. Press button CH to change to an unoccupied channel.

When an unoccupied video frequency is located, change the

video band and channel on the quadcopter to match the monitor.

To change the quadcopter video frequency:

1. Remove the rear top cover of the quadcopter.

2. Raise the camera by pushing down on the camera icon on

the top of the quadcopter.

3. Power on the ﬂ ight control transmitter.

4. Power on the aircraft and allow it to initialize. The digital

display repeatedly shows the current band followed by

the channel.

5. Press and hold the band/channel button until the digital

display ﬂ ashes the current band continuously.

6. Press and release the band/channel button to change to

the desired band.

7. Wait approximately 5 seconds until the digital display

shows the band followed by the channel.

8. Press and release the band/channel button to change to

the desired channel. Conﬁ rm the video feed is clear in the

monitor. Repeat steps 5-8 to ﬁ nd a different channel if the

video is not clear.

9. Place the monitor in the cradle on the transmitter or

inside the goggle frame and replace the rear top cover of

the quadcopter.