Blade Vusion 250 V2 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drony Blade Vusion 250 V2. Blade Vusion 250 V2 18 stron. Fpv-ready racing drone rtf

Installing the Propellers

Refer to the illustration for the proper motor rotation and

propeller location.

The propellers have "CW" or "CCW" marked on the blades

to show proper location and rotation. Match the propeller

location to the illustration.

Secure the propellers using the propeller nuts.

Do not overtighten the nuts as damage to the propellers or

motors may result.

IMPORTANT: The motor shafts and nuts at the "CW"

propeller locations are reverse threads.

To replace the front motor arms:

1. Remove the video antenna.

2. Remove the four screws from the canopy and slide the

canopy from the front of the quadcopter.

3. Remove the two screws from each of the motor arms.

4. Pull the arms from the side of the quadcopter frame.

5. Reverse the process for re-assembly.

WARNING: Remove the propellers from the motors prior to performing any troubleshooting or maintenance.

Failure to do so may cause serious injury if the motors start unexpectedly.

√

Make sure the battery is disconnected before cleaning. Remove dust and debris with a soft brush or a dry,

Cleaning

lint-free cloth.

Motors

Replace the motor when the model will not ﬂ y steady or veers off when doing a climb out.

Wiring

Make sure the wiring does not block moving parts. Replace damaged wiring and loose connectors.

Make sure there are no loose screws, other fasteners or connectors. Do not over-tighten metal screws in plastic

Fasteners

parts. Tighten screws so the parts are mated together, then turn the screw only 1/8th of a turn more. Do not use

threadlock on or near plastic parts.

Make sure there is no damage to the propellers or other parts that move at high speed. Damage to these parts

Propellers

includes cracks, burrs, chips or scratches. Replace damaged parts before ﬂ ying.

To replace the rear motor arms:

1. Remove the battery compartment cover.

2. Remove the two screws from each of the motor arms.

3. Pull the arms from the side of the quadcopter frame.

4. Reverse the process for re-assembly.

CCW