Cub Cadet CC 2000 Manuel de l'opérateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cub Cadet CC 2000. Cub Cadet CC 2000 20 pages. 2-cycle trimmer
Également pour Cub Cadet CC 2000 : Liste des pièces (2 pages)
Imprimer la page
Operation(continued)
DECORATIVE
TRIMMING
Decorative trimming is accomplished
by removing all
vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment
is
at a 30 ° angle to the ground (Fig. 5-6).
Fig. 5-6
Section 6
Maintenance
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about these
procedures take your unit to an authorized service
dealer.
MAINTENANCE
SCHEDULE
These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.
To prevent serious injury, never do maintenance
or repairs with unit running. Always do
maintenance
and repairs on a cool unit.
Disconnect
spark plug wire to ensure the unit will
not start.
WHEN
Before Starting Engine
Every 10 Hours
Every 25 Hours
MAINTENANCE
NEEDED
Fill fuel tank with correct oil and fuel mixture.
Clean and re-oil air filter.
Check spark arrestor and clean
Check spark plug condition and gap
GO TO:
P_e9
P_e15
P_e15
P_e17
Bump Knob
Y
LINE INSTALLATION
This section covers both Membrane line and standard
single line installation.
Always use manufacturer's
0.095 inch (2.41 mm)
replacement
line. Using line other than specified may
make the engine overheat or fail.
i
W
, -
Never use metal-reinforced
line, wire, chain, or
rope, etc. These can break off and become
dangerous
projectiles.
12