Cub Cadet CC 2000 Manuel de l'opérateur - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cub Cadet CC 2000. Cub Cadet CC 2000 20 pages. 2-cycle trimmer
Également pour Cub Cadet CC 2000 : Liste des pièces (2 pages)

Imprimer la page

Maintenance (continued)

Outer Spool

Shaft

Inner Reel___

___

Spring

Fig. _

Indexing Teeth

Fig. 6-3

There are two methods to replace the trimming line.

• Wind the inner reel with new line

• Install a prewound inner reel

Winding the Existing Inner Reel

Hold the outer spool with one hand and unscrew

the bump knob counterclockwise

(Fig. 6-1).

Inspect the bolt inside the bump knob to make sure

it moves freely. Replace the bump knob if

damaged.

Remove the inner reel from the outer spool (Fig. 6-2).

Remove spring from the inner reel (Fig. 6-2).

Use a clean cloth to clean the the inner reel, spring,

shaft, and inner surface of the outer spool.

Check the indexing teeth on the inner reel and

outer spool for wear (Fig. 6-3). If necessary, remove

burrs or replace the reel and spool.

NOTE: Membrane

line can only be used with the

inner reel with the slotted

holes. Single line can be

used on either type of inner reel Use Figure 6-4 to

identify the inner reel you have.

NOTE: Always use the correct line length when

installing trimming

line on the unit. The line may

not release properly if the line is too long.

Single Line Installation

Go To Step 8 for Membrane Line Installation

6. Take approximately

20 feet (6.1 m) of new trimming

line, loop it into two equal lengths. Insert each end

of the line through one of the two holes in the inner

reel (Fig. 6-5). Pull the line through the inner reel so

that the loop is as small as possible.

Slotted Holes

For Use with

Single Line ONLY

Fig. 6-4

For Use with

Membrane

Single Line

Fig. 6-5

Loop