Cub Cadet 19A70005100 Manuel de l'opérateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cub Cadet 19A70005100. Cub Cadet 19A70005100 20 pages. Twin rear bagger
Imprimer la page
8.
Install both bag assemblies with the tight mesh sides facing
forward, onto the bag support brackets by inserting the
front edge in first, as seen in 1 of Fig. 4-16, and setting the
back edge down until it fits into the assembly (2).
9.
Install the rubber chute strap (723-04008A) on the chute elbow
using a clevis pin (711-05063), flat washer (736-0204) and
Bow-tie cotter pin (714-04040) found in hardware pack
689-00091. See Fig. 4-17.
Note: Attach the end of the strap with the mounting hole
closest to the end of the strap, as shown in 4-17.
10.
Install the ball pin (911-04069) from hardware pack 689-00091
into the hole in the front of the mower deck as seen in Fig.
4-18, and secure with a flange lock nut (712-04064), from
the same hardware pack.
12
s
4 — a
ectiOn
sseMbly
1
2
Figure 4-16
Figure 4-17
& i
nstallatiOn
Figure 4-18
11.
With the tractor's discharge chute raised up and held open,
install the chute elbow over the chute opening by placing
the top, rear edge of the chute elbow over the rear of the
deck opening, then pivoting the chute elbow down and
over the chute opening. See Fig. 4-19.
Figure 4-19
Note: For the chute elbow to be properly installed, the
bottom edge must fall over the bottom of the deck
opening. See Fig. 4-20.