Discount Equipment KL-14 Manuel d'instruction de l'opérateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction de l'opérateur pour {nom_de_la_catégorie} Discount Equipment KL-14. Discount Equipment KL-14 16 pages. 14” compact saw
Également pour Discount Equipment KL-14 : Manuel (12 pages)
Imprimer la page
Disconnect the machine from the power source before performing any work on the
equipment (i.e. changing the blade). To disconnect the power source on gasoline engine
models, remove the spark plug lead.
•
Make sure you have the proper blade for the job. Determine the hardness and composition of the
slab. Give your dealer complete information including whether re-bars are present, the desired
depth of the cut, and the length of the cut. If in doubt, contact the blade manufacturer.
Inspect the blade before installing. Check diamond blades for cracks, loose segments
and oversize, worn, or out-of-round arbor holes. (Figure 1) Do not use any questionable
blade since serious personal injury and/or damage of property can result. Do not
use warped, twisted, or out-of-balance blades. Unbalanced blades will wear excessively, vibrate
and damage both arbor shaft and bearings. Do not use a blade without a drive pinhole (Figure 5).
For safety reasons, EDCO does not recommend the use of any abrasive blades. Abrasive
blades can break and cause serious personal injury to operator and/or bystandards. If
abrasive blades are used by choice, use only reinforced abrasive blades. Inspect
abrasive blades carefully.
Never exceed the maximum operating speed of the blade. Be sure to match the blade
speed rating with the arbor shaft speed on the machine. The standard models of the
KL-14, SK-14, SB-14, DS-18 have an arbor shaft speed (uploaded) of 3600 RPM and
3000 RPM under load.
•
Do not remove or lift the blade guard unless machine is stopped and all power is disconnected.
Be sure to reinstall blade guard before reconnecting the power source.
•
To change the blade unbolt and pull up on front of guard(Figure 6). Then rotate the guard back until
it rests on rear wheel(Figure 7).
•
Be sure the arbor shaft, backing plate, and blade cap are clean and in good condition. Make sure
the threads are clean and undamaged. If any damage is detected, consult Discount-equipment.
•
The backing plate and blade cap should be the same diameter, do not use if they are
different diameters.
Figure 6
800-638
Changing Blades
EQUIPMENT DEVELOPMENT CO., INC.
EQUIPMENT DEVELOPMENT CO., INC.
800-
KL14-I-1017
Figure 7
Page 9