Discount Equipment KL-14 Manuel d'instruction de l'opérateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction de l'opérateur pour {nom_de_la_catégorie} Discount Equipment KL-14. Discount Equipment KL-14 16 pages. 14” compact saw
Également pour Discount Equipment KL-14 : Manuel (12 pages)

Discount Equipment KL-14 Manuel d'instruction de l'opérateur
FOR WET CUTTING: Attach the water supply. A flow rate of approximately 2 gallons per minute
(minimum) is required. Attach the water hose to the coolant valve. Use the valve to control the
flow of water.
FOR DRY CUTTING: Provide a respirator and dust control system.
FOR GASOLINE MODELS: Put the engine stop switch and the machine stop switch in the "RUN"
position. Consult the engine manufacturers operating instructions and follow the directions for starting
and breaking in the engine.
BEFORE STARTING THE ENGINE OR MOTOR: Raise the saw blade clear of the working surface.
The blade is raised using the depth control handwheel knob mounted on the lower handle assembly
(Figure 2) . Lift the knob to unlock and turn the handwheel clockwise until the blade is clearly
off the ground.
START ENGINE AND ALLOW IT TO REACH OPERATING SPEED: With the handle in the full upright
position(Figure 3)position the saw over the cutting line. Bring the engine to full speed. Lower the blade into
the slab surface by slowly turning the depth control handwheel knob. NOTE - the 14 inch blade has a
maximum cutting depth of 4 3/4". Step cut in 1" increments for depths greater than 1". Do not allow the
arbor flanges to contact slab surface.
When the selected cutting depth is reached, lock the depth control handwheel knob and proceed to
push the saw forward. The saw blade must remain straight, do not twist, and do not force blade, the
engine or motor should not strain when cutting.
TO STOP THE MACHINE: Stop forward motion. Turn the depth control handwheel knob clockwise to
raise the blade clear of the cut. Push the throttle to idle. Turn ignition or power switch off and let the engine
come to a complete stop. Turn off the water supply.
WHEN MANEUVERING THE SAW: Make sure the blade is raised high enough so it does not strike
the slab surface. Damage to blade may occur with inadvertent contact with the slab or other object.
DO NOT FORCE BLADE WHILE CUTTING.
IF THE POWER SOURCE STALLS IN THE CUT: Raise the blade completely out of the cut.
Disconnect the power source (i.e. the spark plug wire on a gasoline engine or disconnect an electric
model at the machine). Inspect the blade flange nut/bolt to verify that they are still tight, and inspect
the blade for damage. Replace damaged (or questionable) blades immediately.
WHEN TRANSPORTING THE SAW: Be sure to remove the blade. Before removing the blade,
disconnect the power source before lifting or removing any guard. See the directions for Changing
Blades on (page 9) .
WHEN STORING THE SAW: Loosen handle locks. Pull handle up and rotate forward(Figure 4).
Figure 2
800-638
Operating Instructions
EQUIPMENT DEVELOPMENT CO., INC.
EQUIPMENT DEVELOPMENT CO., INC.
Figure 3
800-
KL14-I-1017
Figure 4
Page 7