ARNOLD 60455 Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ARNOLD 60455. ARNOLD 60455 20 pages. Mirrorball motorcontroller

Imprimer la page

Mirrorball Motorcontroller

Setup and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the device in, always make sure that the power supply matches the product

specification voltage. Do not attempt to operate a 110 V specification product on 230 V power, or vice

versa.

Connect the device to the main power supply.

●

The motor must be installed at a vibration-free, oscillation-free and fire-resistant location. Make sure

that the motor axle points are facing the bottom.

●

If the motor and the mirror ball are to be operated above persons, a hazard analysis based on the

location and application must be performed in order to ensure dimensioning and measures for a

safe operation. Both the motor and the mirror ball meet the professional safety regulations regarding

safety and operation.

●

The installation of the mirror ball has to be carried out in a way that it can hold 10 times the device's

weight for 1 hour, without any harming deformation.

●

The installation must always be secured with a safety attachment, constructed in a way that no part

of the installation can fall down if the main attachment fails.

●

When rigging, derigging or servicing the fixture, staying in the area below the installation place, on

bridges, under high working places and other endangered areas is forbidden.

●

The operator has to make sure that safety-related and machine-technical installations are approved

by an expert before taking into operation, after every four years in the course of an acceptance test

and once a year by a skilled person.

Control Modes

There are 2 modes:

One Mirrorball Controller (Manual)

Place the device on a flat surface. Leave at least 0,5 meter on all sides for air circulation.

01)

02) Plug the adapter into a proper electric power supply socket.

03) When the Mirrorball Controller is not connected with a DMX cable, it functions as a stand-alone

device. See page 14 for more information about Manual mode.

Multiple Mirrorball Motorcontrollers (DMX control)

01) Place the device on a flat surface. Leave at least 0,5 meter on all sides for air circulation.

02) Use a 5-pin DMX cable to connect the Mirrorball Motorcontroller and a light controller.

03) Link the devices as shown in Fig. 04 on page 10. Connect a DMX signal cable from the first device's

DMX "thru" socket to the second device's "in" socket. Repeat this process to link the second, third,

and fourth devices.

04) Supply electric power: Plug the adapter into a proper electric power supply socket, starting with the

first device. Do not supply power before the whole system is set up and connected properly.

Ordercode: 60455

●

Manual

●

DMX-512 (1CH, 2CH)