ARNOLD 60455 Handmatig - Pagina 10
Blader online of download pdf Handmatig voor {categorie_naam} ARNOLD 60455. ARNOLD 60455 20 pagina's. Mirrorball motorcontroller
Mirrorball Motorcontroller
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the device in, always make sure that the power supply matches the product
specification voltage. Do not attempt to operate a 110 V specification product on 230 V power, or vice
versa.
Connect the device to the main power supply.
●
The motor must be installed at a vibration-free, oscillation-free and fire-resistant location. Make sure
that the motor axle points are facing the bottom.
●
If the motor and the mirror ball are to be operated above persons, a hazard analysis based on the
location and application must be performed in order to ensure dimensioning and measures for a
safe operation. Both the motor and the mirror ball meet the professional safety regulations regarding
safety and operation.
●
The installation of the mirror ball has to be carried out in a way that it can hold 10 times the device's
weight for 1 hour, without any harming deformation.
●
The installation must always be secured with a safety attachment, constructed in a way that no part
of the installation can fall down if the main attachment fails.
●
When rigging, derigging or servicing the fixture, staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
●
The operator has to make sure that safety-related and machine-technical installations are approved
by an expert before taking into operation, after every four years in the course of an acceptance test
and once a year by a skilled person.
Control Modes
There are 2 modes:
One Mirrorball Controller (Manual)
Place the device on a flat surface. Leave at least 0,5 meter on all sides for air circulation.
01)
02) Plug the adapter into a proper electric power supply socket.
03) When the Mirrorball Controller is not connected with a DMX cable, it functions as a stand-alone
device. See page 14 for more information about Manual mode.
Multiple Mirrorball Motorcontrollers (DMX control)
01) Place the device on a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 5-pin DMX cable to connect the Mirrorball Motorcontroller and a light controller.
03) Link the devices as shown in Fig. 04 on page 10. Connect a DMX signal cable from the first device's
DMX "thru" socket to the second device's "in" socket. Repeat this process to link the second, third,
and fourth devices.
04) Supply electric power: Plug the adapter into a proper electric power supply socket, starting with the
first device. Do not supply power before the whole system is set up and connected properly.
Ordercode: 60455
●
Manual
●
DMX-512 (1CH, 2CH)
9