Abbey B06-071 Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Abbey B06-071. Abbey B06-071 4 pages. Rs232 to rs485 converter

Imprimer la page
Introduction
The B06-071 converts RS-232 serial data to and from RS-485. It is designed for use
with the Topcat and Swampfox RTUs to allow communication with one or more
IEDs with isolated RS485 interfaces.
CN1
RS-232
B06-071 Layout
Connection to Abbey Systems RTUs
Use an RJ-45 patch cable to connect CN1 to the appropriate serial port on the RTU.
Pin Function
1
Power (8-27.6V DC)
2
NC
3
CTS to RTU (Linked to PIN 4)
4
RTS from RTU
5
Flow Control Out (Always Idle)
6
Transmitted Data from RTU
7
Received Data to RTU
8
GND
The status LEDs provide an indication on the
control and data signals between the RTU
and converter:
Connection to Non-Abbey Equipment
The converter requires the RTS signal to control the RS-485 transmitter. The signal
must be active during RS-485 transmission, and inactive during reception.
Power is supplied via PIN 1 and can range from +8 to +27.6V DC, which is normally
supplied from the Abbey Systems RTU. A splitter cable can be used to power the
converter from a suitable supply if this not available on the equipment's serial port.
B06-071 Installation Guide
Status
LEDs
Dir
-
-
Out
In
8
Out
In
Out
-
LED
RTS
TXD
RXD
1
CN2
RS-485
1
Indicates
RTS signal from the RTU: Green
Data received from RTU: Yellow
Data sent to RTU:
IG-518-4-2012-Feb
Red