3D Fun Printz Pen Holder Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3D Fun Printz Pen Holder. 3D Fun Printz Pen Holder 3 pages. For cricut maker/air explore series.

Imprimer la page

You will need to remove the Cricut pen holder from the left hand accessory head. To

remove this undo the latch and gently press upwards on the pen holder from below. It should

pop out with a little pressure. Please see my product youtube video for a demo.

or scan here

https://youtu.be/p03qm9UUsGI

To fit a pen into the holder clip the alignment clip onto the holder as shown. It should remain

loosely in place without holding. There are tabs that fit into the holes on the pen holder

Now insert your pen so the nib just touches the small recess inside the alignment clip you just

fitted. Once the nib is touching gently tighten down the thumbscrew.

The thumbscrew does not need to be tightened down hard. Just enough to grip the pen

Now insert the pen and holder into your machine