3D Fun Printz Pen Holder 매뉴얼 - 페이지 2

{카테고리_이름} 3D Fun Printz Pen Holder에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Fun Printz Pen Holder 3 페이지. For cricut maker/air explore series.

You will need to remove the Cricut pen holder from the left hand accessory head. To

remove this undo the latch and gently press upwards on the pen holder from below. It should

pop out with a little pressure. Please see my product youtube video for a demo.

or scan here

https://youtu.be/p03qm9UUsGI

To fit a pen into the holder clip the alignment clip onto the holder as shown. It should remain

loosely in place without holding. There are tabs that fit into the holes on the pen holder

Now insert your pen so the nib just touches the small recess inside the alignment clip you just

fitted. Once the nib is touching gently tighten down the thumbscrew.

The thumbscrew does not need to be tightened down hard. Just enough to grip the pen

Now insert the pen and holder into your machine